Time tracking

A timer on a task, or time logged after the fact. It needs two things: the Pro plan, and the feature switched on for the project.

Turning it on

Project settings, then Features, then Time tracking. It is off by default, so a project that does not care about hours never shows a timer. An admin on the project or the workspace flips it.

Both conditions have to hold. With the switch on but the workspace below Pro, starting a timer is refused; with Pro but the switch off, the task says time tracking is disabled for this project.

Using it

The task's Time tracking section has the controls, and the heading shows the task's total.

  • Start runs a timer, and the button becomes Stop with the time so far.
  • Add time logs time you already spent: hours, minutes and an optional note.
  • A chip in the sidebar follows your running timer wherever you are, with its own Stop, so you do not have to find the task again to stop it.

Each entry is yours. The task shows everyone's entries and the total across them, and two people can run a timer on the same task at once.

One timer at a time

You can have one running timer across the whole workspace, not one per task. Starting a second tells you a timer is already running. This is on purpose: two of your own timers running at once would mean one of them is wrong.

Rounding

Stopping a timer rounds up to the next whole minute, so a thirty-second timer logs one minute. Manual entries take anything from one minute to 24 hours.

To change an entry, stop the timer first; a running entry cannot be edited. You can edit and delete your own entries, and a project admin can edit or delete anyone's.

What it does not do

Worth knowing before you plan around it, because the gap is larger than you would expect:

There is no time report. The per-task total and your running-timer chip are the only places logged time appears. There is no timesheet, no per-person total, no project report, no analytics card, and time is not in the task export.

Logged time is not compared against the estimate. The task shows what was logged. Estimated against actual is not something it works out for you.

So this is a record of hours on a task, readable on that task. If you need to invoice from it or report on it across a month, plan to pull it out through the REST API.

What happens if the plan or the switch changes

Nothing is deleted, and nothing gets stuck:

  • Switch the feature off and existing entries stay, still listed on their tasks. New timers and manual entries are refused.
  • A running timer can always be stopped, even after the switch goes off or the plan drops. It would be worse to leave a timer running with no way to end it.

Who can do what

ActionNeeds
See entries and the totalAny project member, guests included
Start, stop, log, edit and delete your ownMember or above
Edit or delete anyone's entryProject admin
Start a timer or log time at allThe Pro plan, and the project switch on

Troubleshooting

What you seeWhat it means
"Time tracking requires the Pro plan or higher."Starting a timer and logging time need Pro. Reading and stopping do not.
"Time tracking disabled for this project"The project switch is off, in Settings, then Features.
"You already have a running timer"One running timer per person. Stop the other one, which the sidebar chip will take you to.
"Stop the timer before editing"A running entry cannot be edited. Stop it first.
"Manual entries cannot exceed 24 hours"Split a longer stretch into separate entries.
"Minutes must be greater than zero"An entry needs at least a minute.
"Only the owner or an admin can edit this entry"Entries belong to the person who logged them.
"No running timer on this issue"The timer was already stopped, possibly from the sidebar chip.
A 20-second timer logged a minuteStopping rounds up to the next whole minute.
You cannot find a time reportThere is not one. Pull the entries through the API.
  • Estimates: sizing work before it starts.
  • Tasks: the panel the timer lives in.
  • REST API: getting the entries out.